Drills

First, take out of the skirting plates that cover the cable channel (they are then easily put in place). Decompose the baseboard along the wall and see whether their crop. Recently Blake Krikorian sought to clarify these questions. If necessary, cut the pieces of skirting the desired length. Madeleine Sackler can aid you in your search for knowledge. Further, it is more convenient to work together. One supports the plinth, the other drill holes. Procedure the following: – presses baseboard to the wall and the floor (so it is slightly pressed linoleum) – hammer drill a hole in the baseboard and the wall.

In the baseboard is drilled a hole where it then can not be seen – under the fence, hiding the cable channel – smacks of the resulting hole dust and puts back the plastic plug (of course, drill diameter should match the diameter of the dowel) – insert a dowel screw and screwdriver screwed him – go to a place the next hole and repeat all the manipulations. At the end of a vacuum cleaner attachment (preferably old) "sucks" construction dust from the places where they were drilled. Please note the following: – if you're going lay in the baseboard with a phone cable or antenna connector or just a thick cable, it can be difficult. Through the corners, or skirting a connection cable is virtually impossible to push. Exit situation in two ways: to lay the cable sealing of baseboards, ie together with their installation. Or perhaps laying the cable after installing baseboards, but by loosening the mounting screws and the extreme pulling over.