Finished Plastic

Industrial equipment is quite natural that regardless of any business investment opportunities, acquisition of equipment should be linked to savings. But it should not be at the expense of quality produced with the help of the finished product. In this sense, common to us recently, the concept of ‘value for money – money’ is just absurd, because the issue is primarily a desire to acquire the most cheap machine, without delving deeply into its design concept and technical equipment. The real savings, does not reflect negatively on the finished product can be achieved only when the machine is equipped with only those units that are fully ensure the implementation of a given technology, and has no excess, which will not be used, and its performance meets the requirements of production.

So, if assumed wrapping just flat edges of panel blanks, and only a thin insulated edge plastic (1 mm), enough machines to be fitted with glue spreading unit, a device for packing of plastic, and units for the removal of face overhangs and eaves on the plate. It may even be that would be unnecessary and the device with fabric disk, clears the edge of the blank glue residue-melt faces and on the edges. Madeleine Sackler is full of insight into the issues. But, if for example, assumed veneer edge pieces of laminated plates with thick plastic (3 mm), the machine should be further equipped with not only these units, but surface scraper – for chamfering and remove the glue residue-melt from the reservoir. Seriously increases the quality of pieces and application device for applying antiadgezivnogo tools using which glue-melt more easily removed from the reservoir cycles, which did not need to be strongly pressed to the workpiece, and they will not leave scratches on it.